DINS to adjust Duty Cycle in 4.0?
Posted: Sat Jan 02, 2016 12:40 pm
Hi guys,
First post here. I have my BCS 462 up and running my control panel. My set up is a 3 burner rig with RIMS. 4 DINS on the control panel. 1st is set to cancel the alarm. 2nd is to change a state. I would like to program the 3rd and 4th DINS to increase or decrease (respectively) a duty cycle for my Boil Kettle burner. Is there any way to do this in the 4.0 firmware? Thanks!
Matt
First post here. I have my BCS 462 up and running my control panel. My set up is a 3 burner rig with RIMS. 4 DINS on the control panel. 1st is set to cancel the alarm. 2nd is to change a state. I would like to program the 3rd and 4th DINS to increase or decrease (respectively) a duty cycle for my Boil Kettle burner. Is there any way to do this in the 4.0 firmware? Thanks!
Matt