Need help designing a Process
Posted: Sat Jan 23, 2016 11:02 am
Hi,
I have a process I made that lets me fill and heat my HLT.
Its not exactly working correctly however.
There is an electric valve that opens and begins filling the HLT when I start the process.
I want to have the valve turn off when the high level float switch is actuated, which is set as DIN 0 I believe.
Only problem is that when the float switch is "on", the process doesn't proceed to the next state, which should turn off the valve.
I set the exit state to DIN 0 (the high level float switch), when ON, Proceed to Next State.
I believe that the float switch is working properly, but I will very functionality with an Ohm meter when I have the chance. I had done so earlier, but have since made the wiring look fancy soldering it to the longer cable to the panel and added sheath and shrink wrap, so I suppose that there is a very small chance I goofed up somewhere in this step, but I doubt it, and suspect a bigger problem exists.
Thanks.
I have a process I made that lets me fill and heat my HLT.
Its not exactly working correctly however.
There is an electric valve that opens and begins filling the HLT when I start the process.
I want to have the valve turn off when the high level float switch is actuated, which is set as DIN 0 I believe.
Only problem is that when the float switch is "on", the process doesn't proceed to the next state, which should turn off the valve.
I set the exit state to DIN 0 (the high level float switch), when ON, Proceed to Next State.
I believe that the float switch is working properly, but I will very functionality with an Ohm meter when I have the chance. I had done so earlier, but have since made the wiring look fancy soldering it to the longer cable to the panel and added sheath and shrink wrap, so I suppose that there is a very small chance I goofed up somewhere in this step, but I doubt it, and suspect a bigger problem exists.
Thanks.