Hi,
I have implemented mash step ramp and wait as separate states.
State 1 (ramp) sets output to PID @ 62C, exit condition is when Temp reaches 62C
State 2 (wait) sets output to PID @ 62C, exit condition is the timer reaching 0.
This works nicely, but it means I need to change a mash temperature in three places.
I was just wondering if there's a better approach to this?
Mash ramp & wait
-
- Posts: 383
- Joined: Wed Feb 09, 2011 3:43 pm
- Bot?: No
- Location: Clearwater, FL
- Contact:
Re: Mash ramp & wait
This was requested in the following post:
http://www.embeddedcontrolconcepts.com/ ... f=11&t=622
http://www.embeddedcontrolconcepts.com/ ... f=11&t=622