Page 1 of 1
Setting up public access for Mac?
Posted: Wed May 06, 2009 3:44 am
by nuke314
Can any one post how to set up the public access point? I tried to follow the wiki page instructions but it did not work for me. Any help would be great. Thanks.
Re: Setting up public access for Mac?
Posted: Wed May 06, 2009 5:53 am
by np0x
Which wiki instructions did you follow? Are you talking about the observer password? or is this the more difficult question of how to poke a hole in your firewalls so people from the outside can see your bcs?
Re: Setting up public access for Mac?
Posted: Wed May 06, 2009 3:51 pm
by nuke314
The second one. I spent a couple hours trying to follow the instructions below, with no luck. was hoping to get some info on this. I sooo want to show this system off.
http://www.embeddedcontrolconcepts.com/ ... g_Remotely
Re: Setting up public access for Mac?
Posted: Sun May 10, 2009 6:30 pm
by np0x
You found the right page, you need to setup your router to port forward a high port(like 8080 or 8000) to the port 80 of your bcs's ip address(e.g. 192.168.1.200) on your private network. This is neither a mac or a pc thing, more of a linksys/dlink kinda thing.