BSC Fermentation Controller

Post pictures of your System
Post Reply
jward
Posts: 69
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

BSC Fermentation Controller

Post by jward »

Made good progress this weekend building out BCS based fermentation controller.

Image
Image
Image
JonW
Site Admin
Posts: 1726
Joined: Sun Jul 18, 2010 7:51 am
Bot?: No
Location: Huntington Beach, CA
Contact:

Re: BSC Fermentation Controller

Post by JonW »

Looks like you switched over to the Electronics Salon relay module. Is that the same PS you were originally using?

Git 'r done!!!
jward
Posts: 69
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

Re: BSC Fermentation Controller

Post by jward »

That is the Electronics Salon relay, but I think the other one was Electronics Salon too but the DIN version. I was going to go with DIN but decided better of it. It's a different PS. I was going to use the one from a disk drive enclosure but came by this smaller one that only does 12v.
jward
Posts: 69
Joined: Sun Oct 04, 2009 9:38 pm
Bot?: No

Re: BSC Fermentation Controller

Post by jward »

I worked through some grounding issues with the help of JonW (thank you!) adding a connector block for grounding wires:

Image

Here is a photo of the system almost in action. It's setup and running but without an active fermentation my garage is colder then the fermentation would be:

Image

I am also amused that in the photo I can see the red and green colors in the temperature leds. Directly viewing them not so much.
Post Reply