Hey there,
so i purchased a BCS 462 recently, after completing my project and powering the thing up for the first time i find it is not closing any of the 5VDC relays it is wired to, i have tested it again and again, it has 6.2VDC input from the power supply and the best i get at the DO pins is 2.6VDC.
ive searched the forums and this seems to be the only problem like this i can find that does not come down to the power supply. I am hoping you may have a solution, or at worst case some sort of warranty or replacement system? please let me know,
Thanks
Matt
Low Output Voltage
Re: Low Output Voltage
If you are getting. 6.2 on the Pins of the Wall wart、I understand there is an on board 5 volt regulator that may be able to be changed by Brewe Hardware
-
- Posts: 2
- Joined: Thu Feb 08, 2018 5:18 am
- Bot?: No
Re: Low Output Voltage
Just called them, they’ll look into it and email me back:) worst case I may try and replace it myself:)