Using the Ramp function in a fermentation chamber and v3.4.5 will not dynamically display the ramp set temp on the main control page without refreshing the page. Is this the way its supposed to be?
Ramp Temp not updating on Main Control Page
Re: Ramp Temp not updating on Main Control Page
Confirming the temperature showing in your screen shot of 59.4 degrees under the temperature setpoint is not changing?
Re: Ramp Temp not updating on Main Control Page
Yes...the temp displayed in the lower right hand corner is not updating except if I refresh the entire screen. This is only a display issue as the info on the data log page is accurate.
picky, but I think it should dynamically update.
picky, but I think it should dynamically update.
Re: Ramp Temp not updating on Main Control Page
Agreed, it should probably be dynamic update. I'll add it to the list.
-
- Posts: 29
- Joined: Tue Aug 24, 2010 4:33 am
- Bot?: No
Re: Ramp Temp not updating on Main Control Page
On a similar problem, on the collect data screen, one of the possible data inputs is the temperature setpoint. Why are these tied to the 4 temperature measurements and not to the setpoints for the 6 outputs? Would be nice to see the setpoint ramp up or down along with the actual temperature.